HPE ProLiant DL560 Gen10 - Installing a CPU Mezzanine UPI Performance Kit

9. Install the air baffle (Installing the air baffle on page 58).
10. Install the access panel (Installing the access panel on page 56).
11. Install the server into the rack (Installing the server into the rack on page 48).
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server on page 53.
Installing a CPU Mezzanine UPI performance kit
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-10 Torx screwdriver
• The components included with the hardware option kit
Procedure
1. Powering down the server on page 53.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 53).
• Remove the server from the rack (Removing the server from the rack on page 54).
4. Remove the access panel (Removing the access panel on page 55).
130 Installing hardware options