a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 31).
b. Remove the server from the rack (Remove the server from the rack on page 32).
6. Remove the access panel (Remove the access panel on page 32).
7. Remove the serial cable blank.
8.
Connect the serial cable option, and then secure the cable with two T-10 screws. Then, remove the backing from the
double-sided tape and press down where indicated.
A 5 mm socket is required for this step.
9. Install the access panel (Install the access panel on page 32).
126 Hardware options installation
To Next Page
Loading...
