• The components included with the hardware option kit
• T-10 Torx screwdriver
• An optical drive, if installing
For more information, contact a Hewlett Packard Enterprise authorized reseller.
Procedure
1. Back up all server data.
2. Power down the server (Power down the server on page 31).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a.
Extend the server from the rack (
Extend the server from the rack on page 31).
b.
Remove the server from the rack (Remove the server from the rack on page 32).
5.
Remove the access panel (Remove the access panel on page 32).
6.
Remove the universal media bay blank.
7. Install the 8 SFF display port/USB/optical blank option.
76 Hardware options installation
To Next Page
Loading...
