9. Use a T-10 Torx screwdriver to Install the expansion board.
10.
Connect any required internal or external cables to the expansion board.
11.
Install the primary PCI riser cage (Install the primary PCI riser cage on page 35).
12. Install the access panel (Install the access panel on page 32).
13. Install the server in the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server (
Power up the server on page 31).
Installing an accelerator or GPU in the primary riser cage
Use these instructions to install accelerator options, including GPUs, in the server.
88 Hardware options installation
To Next Page
Loading...
