Extend the server from the rack
Procedure
1. If the rear panel cables are not secured by a cable management arm, do the following:
a. Powering down the server on page 38.
If you are physically powering down the server, open the front bezel to access the power
button. Close the bezel after the server is powered down.
b. Disconnect all peripheral cables from the server.
c. Disconnect each power cord from the server.
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack is
adequately stabilized before extending a component from the rack.
2. Slide the server tray out of the rack:
a. Loosen the server tray thumbscrews.
b. Grasp the tray notch to slide the server out of the rack.
Removal and replacement procedures 41
To Next Page
Loading...
