To replace the component, insert the tab on the blank into the slot on the optical drive bay.
Removing and replacing the cable management arm
CAUTION: Support the CMA during the removal/replacement procedure. Do not allow the CMA to
hang by its own weight during the procedure.
Procedure
1. Slide the server tray out of the rack:
a. Loosen the server tray thumbscrews.
b. Grasp the tray notch to slide the server out of the rack.
2. Open the cable clamps and remove the cables routed through the CMA.
Removal and replacement procedures 55
To Next Page
Loading...
