To replace the component, reverse the removal procedure.
When installing the fan replacement, make sure that the fan clicks into place.
Removing and replacing the fan cage
Procedure
1. Remove the front bezel on page 39.
2. Powering down the server on page 38.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
• Server in tower mode: Position the tower server for hardware configuration on page 40.
• Server in rack mode: Extend the server from the rack on page 41.
6. Remove the access panel on page 45.
7. If the blank is installed in fan bay 1, remove the blank.
8. Remove the fans from the cage.
9. Remove the fan cage:
Removal and replacement procedures 71
To Next Page
Loading...
