• Server in tower mode: Position the tower server for hardware configuration on page 40.
• Server in rack mode: Extend the server from the rack on page 41.
6. Remove the access panel on page 45.
7. Remove the air baffle on page 46.
8. Remove the fan cage on page 47.
9. Disconnect the SAS-power Y-cable from the LTO tape drive.
10. Pull up and hold the blue release latch, and then remove the LTO tape drive.
To replace the component, reverse the removal procedure.
Before installing the replacement LTO tape drive in the media bay, install the mounting screws included in
the spare kit on the tape drive.
Removing and replacing a USB RDX drive
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. Remove the front bezel on page 39.
2. Powering down the server on page 38.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
Removal and replacement procedures 73
To Next Page
Loading...
