To replace the component, reverse the removal procedure.
Removing and replacing the front I/O assembly
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. Remove the front bezel on page 39.
2. Powering down the server on page 38.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
• Server in tower mode: Position the tower server for hardware configuration on page 40.
• Server in rack mode: Extend the server from the rack on page 41.
6. Remove the access panel on page 45.
7. Remove the air baffle on page 46.
8. If installed, remove the fan cage.
9. Remove the blue media device retainer:
a. Release the drive latches.
b. Slide the retainer as shown, and then remove the retainer from the chassis.
76 Removal and replacement procedures
To Next Page
Loading...
