8. Remove the air baffle on page 46.
9. Disconnect the M.2 SATA cables from the enablement board.
10. Remove the M.2 SSD enablement board.
11. Remove the M.2 SSDs.
To replace the component, reverse the removal procedure.
Removing and replacing an M.2 SSD
Prerequisites
Before you perform this procedure , make sure that the following items are available:
• T-15 Torx screwdriver
• Phillips No.1 screwdriver
Procedure
1. Remove the front bezel on page 39.
2. Powering down the server on page 38.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
• Server in tower mode: Position the tower server for hardware configuration on page 40.
• Server in rack mode: Extend the server from the rack on page 41.
6. Remove the access panel on page 45.
Removal and replacement procedures 91
To Next Page
Loading...
