11. To replace the component, reverse the removal procedure.
12. Properly dispose of the old battery.
For more information about battery replacement or proper disposal, contact an authorized reseller or
an authorized service provider.
Removing and replacing the cable clips
Procedure
1. Remove the front bezel on page 39.
2. Powering down the server on page 38.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
• Server in tower mode: Position the tower server for hardware configuration on page 40.
• Server in rack mode: Extend the server from the rack on page 41.
6. Remove the access panel on page 45.
7. Remove the air baffle on page 46.
8. Open the cable clip.
9. Release all cables from the clip.
10. Press and hold the latch, and then slide the clip up to remove it from the chassis.
Removal and replacement procedures 99
To Next Page
Loading...
