Component identification 27
Removing the drive does not cause a logical drive to fail.
The drive is a member of one or more logical drives.
The drive is rebuilding or performing a RAID migration, strip size
migration, capacity expansion, or logical drive extension, or is
erasing.
amber/green
The drive is a member of one or more logical drives and predicts
the drive will fail.
The drive is not configured and predicts the drive will fail.
The drive is not configured by a RAID controller.
The blue Locate LED is behind the release lever and is visible when illuminated.
IMPORTANT: The Dynamic Smart Array B140i Controller is only available in UEFI Boot
Mode. It cannot be enabled in Legacy BIOS Boot Mode. If the B140i controller is disabled,
drives connected to the system board Mini-
SAS connectors operate in AHCI or Legacy mode.
Under this condition:
• The drives cannot be a part of a hardware RAID or a logical drive.
• The Locate, Drive status, and Do not remove LEDs of the affected drives are disabled.
Use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities (on page 154) to enable
or disable the B140i controller (System Configuration → BIOS/Platform Configuration (RBSU)
→ System Options → SATA Controller Options → Embedded SATA Configuration).
NVMe SSD components
Item Component Status Definition
1
Ejects the NVMe drive carrier from the cage.
2
Off
No drive activity
3
LED
Flashing white
Off
Drive is powered on, and configured in system.
Do not remove the drive.
Ejection request pending. Do not remove the drive.
Drive removed from the PCIe bus, and can be ejected.
4
Flashing green
Off
Drive is powered on, and configured in system.
Do not remove the drive.
Ejection request pending. Do not remove the drive.
Drive removed from the PCIe bus, and can be ejected.
5
—
Momentary press to request drive removal from PCIe bus
and ejection. Drive removal request can be denied by
operating system.
To Next Page
Loading...
