Operations 39
7.
Do one of the following:
o For tower models, install the tower bezel (on page 31).
o For rack models, install the security bezel ("Security bezel option" on page 50).
Remove the optical drive
The server supports both DVD-ROM and DVD-RW drives.
1. Do one of the following:
o For tower models, open and remove the tower bezel ("Remove the tower bezel" on page 31).
o For rack models, if installed, remove the security bezel ("Remove the security bezel (optional)"
on page 31).
2. Power down the server (on page 30).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 34).
5. Remove the access panel (on page 32).
6. Remove the air baffle (on page 34).
7. Remove the optical drive:
a. Disconnect and remove the optical drive cable.
b. Remove the screw and lift the carrier.
c. Remove the optical drive from the drive bay.
Remove a drive cage blank
1. Do one of the following:
o For tower models, open and remove the tower bezel (on page 31).
o For rack models, remove the security bezel ("Remove the security bezel (optional)" on page 31).
To Next Page
Loading...
