Hardware options installation 90
o
SFF configuration
14. Install the access panel (on page 33).
15. Do one of the following:
o If the server is in a tower configuration, return the server to an upright position.
o If the server is in a rack configuration, slide the server into the rack.
16. Connect each power cord to the server.
17. Connect each power cord to the power source.
18. Power up the server ("Powering up the server" on page 30).
19. Do one of the following:
o For tower models, install the tower bezel (on page 31).
o For rack models, install the security bezel ("Security bezel option" on page 50).
Processor option
The server supports single and dual-processor operations. When a second processor is installed, fan 1
must also be installed. For more information, see "Hot-plug fans (on page 28)."
To upgrade from E5-2600 v3 processor(s) to E5-2600 v4 processor(s), see Customer Advisory
(c04849981) (http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=c04849981).
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
Processor installation cautions
The server supports single-processor and dual-processor operations.
CAUTION: To avoid damage to the processor and system
board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION: To prevent possible server overheating, always populate each processor socket
with a processor socket cover and a processor blank, or a processor and a heatsink.
To Next Page
Loading...
