Installing an HPE Host Bus Adapter
About this task
To install the component:
Procedure
1. Back up all server data.
2. Power down the server .
3. Disconnect all peripheral cables from the server .
4. Remove the server from the chassis.
5. Place the server on a sturdy, level surface.
6. Remove the access panel.
7. Remove the air baffle.
8. Disconnect all cables from the drive backplane.
9. Remove the drive cage assembly.
NOTE: A second processor is required to install a storage controller in slot 10 of the right 4:1 PCI
riser module.
10. Remove the full-height bracket from the storage controller and attach the low-profile bracket.
For more information, see the documentation that ships with the option.
11. Remove the PCI blank.
• Slot 9
• Slot 10
Installing an HPE Host Bus Adapter 69
To Next Page
Loading...
