HPE StoreEver LTO-8 Ultrium 30750 - Page 33

1. Host SAS controller (HBA) 3. Rear of server
2. Cable to be removed 4. Front of server
4. Connect the replacement cable supplied with the tape drive to the host SAS controller, as illustrated in
the following diagram.
Figure 7: Cable routing with replacement SAS cable
1. Replacement SAS cable 3. Connect replacement SAS cable to disk bay
2. Connect replacement SAS cable to host SAS
HBA
4. SAS connector to tape drive
5. Power connector to server
5. Attach the SAS cable to the SAS connector on the tape drive.
Replacing an existing SAS hard drive cable 33