Need help?Do you have a question about the HPI Racing SAVAGE Flux HP and is the answer not in the manual?
General| Type | Monster Truck |
|---|---|
| Scale | 1/8 |
| Power Source | Electric |
| Motor Type | Brushless |
| Drivetrain | 4WD |
| Battery Type | LiPo |
| Chassis | TVP (Twin Vertical Plate) |
| Width | 427 mm |
| Height | 254 mm |
| Wheelbase | 336.5 mm |
| Suspension | Double Wishbone |
Checks and preparations needed before starting to operate the RC car.
Post-operation maintenance and safety advice for the RC car.
Precautions regarding battery handling, charging, and potential fire hazards.
Guidelines for using LiPo batteries, including C-rating and temperature monitoring.
Recommendations for NiMH batteries, warning against low-quality packs.
Instructions for charging the main battery pack for the RC car.
Steps for preparing the transmitter, including battery installation and switch settings.
Steps for correctly installing the drive battery into the RC car.
Crucial steps for turning the receiver OFF before connecting the battery to prevent loss of control.
Step-by-step guide for setting up the Electronic Speed Controller (ESC).
How to verify the ESC setup by checking LED indicators and sounds.
Explanation of steering wheel and throttle trigger functions and adjustments.
Solutions for issues where the RC car fails to move or respond to controls.
Troubleshooting steps for reversed steering or throttle functions.
Recommended maintenance intervals based on usage frequency.
Guide to maintaining the transmitter and receiver functions.
How to enable and configure the Auto-Lipo low voltage cut-off feature.
To Next Page