HPI 2.4GHz Digital Proportional Radio System Instruction manual
●INTRODUCTION
・Automatically in search of the empty band of 2.4G, a transmitter sets up a band.
Therefore, the conventional crystal change is unnecessary.
・A transmitter has original different ID.
Therefore, a receiver malfunctions with neither other same transmitters nor the transmitter
of other 2.4G.
・Since high-speed digitization of all the dynamic-control signals is carried out,
when a wave is lost, the fail-safe-system function operates and a car stops safely.
Also when the Battery capacity of a receiver is lost, the fail-safe-system function operates.
●SPEC
Transmitter（TF-20、TF-21）
・Frequency band：2.4GHz
・Wave system ：DSSS
・Band separation：1MHz
・Transmission speed：16Kbps
・Control Channel：2CH
・Battery：9V（UM-3×6）
・Operating temperature limits：0～40℃
・Consumption electric current：100mA / 9V
・Dimension：240 ㎜×150 ㎜×80 ㎜
・Weight：304g （With no Battery）
Receiver（RF-30、RC-1）
・Frequency band：2.4GHz
・Receiving sensitivity：－95dBm
・Battery：RF-30 6V 5cell
RC-1 4.8V 4cell
・Operating temperature limits：0～40℃
●FCC Information
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1-this device may not cause harmful interference. and
2-this device must accept any interference received,
Including interference that may cause undesired operation.
The changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna must
not be co-located or operating to conjunction with any other antenna or transmitter.'.
To Next Page
Need help?
General
