English
Deutsch
FrançaisNederlandsItalianoEspañolMagyarSuomiSvenskaČeskyRomânăΕλληνικά
4
Setting price of cost/kWh & over load current:
Press and hold FUNC button for 5 seconds during display state of voltage or current or
power.
Setting price 1:
Press SET button once and release, SET display, the first digital COST.kWh flash, 1)
press UP button to set it
Press SET button once and release, the second COST/kWh flash, press UP 2)
button to set it
Press SET button once and release, the third COST/kWh flash, press UP button 3)
to set it
Press SET button once and release, the fourth COST/kWh flash, press UP button 4)
to set it
Press SET button once and release, the radix point COST/kWh flash, press UP 5)
button to set it
Press SET button once and release, the weekday flash, press UP button to set it6)
Press SET button once and release, the hour of ON TIME flash, press UP button 7)
to set it
Setting price 2:
Press FUNC button once and release after finish Setting price 1, setting price 2. 1)
repeat above steps
Setting OVER LOAD current data:
Press FUNC button once and release after finish setting price 2
Press SET button once and release, SET and AMP display, the first digital MAX. 1)
LOAD flash, press UP button to set it
Press SET button once and release, the second digital MAX.LOAD flash, press 2)
UP button to set it
Press SET button once and release, the third MAX. LOAD flash, press UP button 3)
to set it
Press SET button once and release, the fourth MAX. LOAD flash, press UP 4)
button to set it
The OVER LOAD WARNING will flash when load overtop the setting data. The button
function will failure. You must draw out the appliance or set the OVER LOAD data
again.
To Next Page
Loading...
Need help?
General