1
Introduction
Installation
For natural gas and town gas detection:
the ceiling (typically 0,3m below ceiling) at the room where gas leak can be expected and in a
place where air movements are not impeded by furniture or furnishing.
For LPG gas detection:
place where air movements are not impeded by furniture or furnishing.
Places where the detector should NOT be installed!
1. In an enclosed space (e.g. in cupboard or behind a curtain).
2. Directly above a sink.
3. Next to a door or window.
4. Next to an extractor fan.
5. In an area where the temperature may drop to 16°C or exceed +40°C.
6. Where dirt and dust may block the sensor.
7. In a damp or humid location.
Operation
Warm up state:
1. Plug-in the detector the “POWER” LED lights green and the alarm sounds “DiDi”, Alarm LED
2.
, then the detector is ready
Attention!!
The detector should work according the above mentioned points otherwise it will not provide
the intended security. In that case do again the “Warming up” procedure. If there’s still no good
functioning the detector must be replaced.
Important! Not made for carbon monoxide detection.
Display gas
concentration
change
Gas sensor holes
Buzzer
“ ”
“ ”
The EL-GD10 is a freestanding plug-in gas
detector for LPG, naturalgas. The detector
is made for indoor household use. When
the gas leak concentration reaches certain
preset levels the detector provides a visual
signal (LEDs and numeric display indicate
instant gas leak density) and a very strong
alarm tone. When the gas concentration
goes below these levels the detector
regresses to normal state automatically.
1
4
To Next Page
Loading...
Need help?
General