EasyManuals Logo

HQ TORCH-EMC-02 User Manual

HQ TORCH-EMC-02
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
2
ENGLISH
OPERATING MANUAL
E-1073
Flashlight Radio
R 0.0
Parts Instruction
1. Volume Knob
2. FM/AM Band
3. Tuning
4. Speaker
5. LCD Display
6. Handle
7. Time Set Button
8. Hour Button
9. Min Button
10. Torch-Hi/Lo/Off/Lantern
11. FLASHLIGHT
12. LANTERN
13. Dynamo Handle
14. Battery Door
15. Carry Strap (With antenna)
16. DC IN jack
POWER SOURCE
BATTERY OPERATION
1. Open the Battery Cover.
2. Put 4“AA” size (UM-3) batteries into the battery compartment, making sure that the batteries are installed
in the designated numerical order and that the proper polarities (“+”and“-”) are maintained.
To prevent possible damage to this unit:
* Load new batteries with their polarities (“+” and“-”) aligned correctly.
* Do not apply heat to batteries, or internal short circuit may occur.
* If this unit is not going to be used for a long period of time, remove all batteries and store them in a cool
and dry place.
* Remove spent batteries immediately and dispose them.
* Do not use old and new batteries together. Also never use an alkaline battery with a manganese battery.
To Charge the Built-in Ni-Mh Batteries
1. Forbetterqualityduringcharging,it’sbesttoturnofftheradio,ashlightandlantern.
2. Pull the cranking handle out.
3. Turn the cranking handle at a speed of 120 turns per minute or charge by DC IN, and the built-in batteries
will be full charged in approximately 1 hour.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HQ TORCH-EMC-02 and is the answer not in the manual?

HQ TORCH-EMC-02 Specifications

General IconGeneral
BrandHQ
ModelTORCH-EMC-02
CategoryRadio
LanguageEnglish