IMPORTANT:
Use a standard nano SIM only.
Don’t cut a micro or regular SIM card and insert it into
the nano SIM slot. It’s thicker than the standard nano SIM
card and may get stuck in the slot.
Don’t disassemble any part of the phone.
Don’t try to open the phone or remove the battery by force.
This may damage the phone or its electronics and will
invalidate the warranty.
Don’t throw the tray away.
You need it to insert your nano SIM and microSD
™
cards.
1. With the phone facing up,
insert the tip of the tray
eject tool that came in
the box (or a small bent
paperclip) into the tray
eject hole.
Push the tip all the way
into the hole until the
card tray ejects and then
gently pull the tray out.
2. With the gold contacts
facing down, place your
nano SIM and microSD
cards into the SIM and
SD holders of the tray.
Make sure to align the
cut-off corner of the
nano SIM card to the
notch on the holder.
___ Inserting nano SIM and microSD cards
HTC Desire 12
SIM
gold contacts
cut-o corner
nano SIM
2
1
___ Restarting the phone
To restart your phone when it doesn’t respond to touch
screen or button presses, press and hold the POWER
and VOLUME DOWN buttons (for 12 to 15 seconds)
until the phone vibrates, and then release the buttons.
___ Need help?
Go to www.htc.com/support/ to fi nd the user guide,
how-to articles, and more. Please also read the Safety
and regulatory guide that’s included in the box.
3. When reinserting the
tray, make sure it is
facing up so that the
cards don’t fall out.
Hold the tray with the
microSD card between
your fingers, and then
steadily slide the tray
all the way into the slot.
microSD
gold contacts
3
© 2018 HTC Corporation.
All rights reserved.
HTC and the HTC logo are
trademarks of HTC Corporation.
microSD is a trademark of SD-3C
LLC.
All other company, product
and service names mentioned
herein are trademarks, registered
trademarks or service marks of
their respective owners.
htc.com
91H0xxxx-xxM Rev.A
To Next Page
Need help?
General
