HTC Desire 12+ Insertion And Removal Instructions

IMPORTANT:
Use a standard nano SIM only.
Don’t cut a micro or regular SIM card and insert it into the
nano SIM slot. It’s thicker than the standard nano SIM card and
may get stuck in the slot.
Don’t disassemble any part of the phone.
Don’t try to open the phone or remove the battery by force. This
may damage the phone or its electronics and will invalidate the
warranty.
Don’t throw the tray away.
You need it to insert your nano SIM and microSD ™ cards.
1. With the phone facing up,
insert the tip of the tray
eject tool that came in
the box (or a small bent
paperclip) into the tray
eject hole.
Push the tip all the way
into the hole until the
card tray ejects and then
gently pull the tray out.
2. With the gold contacts
facing down, place your
nano SIM and microSD
cards into the SIM 1,
SIM 2, and SD holders
of the tray. Make sure to
align the cut-off corners
of the nano SIM cards
to the notches on the
holders.
Note: By default,
SIM 1 will connect to the
4G LTE/3G network,
SIM 1
SIM 2
___ Inserting nano SIM and microSD cards
HTC Desire 12+
gold contacts
cut-o corner
nano SIM
2
1

HTC Desire 12+ Specifications

General

Display Size	6.0 inches
Resolution	720 x 1440 pixels
Display Type	IPS LCD
Processor	Qualcomm Snapdragon 450
CPU	Octa-core 1.8 GHz Cortex-A53
GPU	Adreno 506
RAM	3 GB
Internal Storage	32 GB
Front Camera	8 MP
Battery Capacity	2965 mAh
Operating System	Android 8.0 (Oreo)
Weight	157.5 g
SIM	Dual SIM (Nano-SIM, dual stand-by)
Rear Camera	13 MP + 2 MP
Colors	Black, Silver
Dimensions	158.2 x 76.6 x 8.4 mm (6.23 x 3.02 x 0.33 in)