11. Install the secondary pulley on the center hub.
12. Push the bearing onto the center pulley.
Tool number: 593 54 12-01
13. Push the center pulley into the center hub.
Tool number: 593 54 14-01
14. Install the snap ring.
7.9 Idle pulleys
7.9.1 To disassemble the idle pulleys
1. Remove the idle pulley.
2. Remove the shaft with a press. Use a mandrel with
a maximum diameter of 16 mm.
48 - Repair and servicing 950 - 001 -
To Next Page
Loading...
