!
All attachments, besides the table top, are done with
the following hardware: Machine Screw
,
a washer
, and a Nut .
1
Insert rubber feet onto ends of legs .
Notice: the correct end has two rectangular holes.
2
Attach the Long Center Frame
Support
to the legs .
Repeat again with remaining
parts
and .
3
Attach the two Short Center
Frame Supports
to one of the
assembled sides from Step 2.
4
Attach the remaining assembled side from
Step 2 to the parts assembled in Step 3
4
An adjustment nut/bolt goes through the center of
the foot and can adjust the stand on uneven floors
To Next Page
Loading...