Below are the different accessory mechanisms that follow ISO standards:
1/4” bolt design
Please refer to ISO 1222-2010, Figure 1 on page 1.
Stabilizing pin design
VIVE Tracker (3.0) leverages the design from ISO 1222-2010, Figure 5 on page 3. For
details on dimensions and tolerances, please refer to pages 13-17. It is suggested to
apply the stabilizing pin for better tracking performance.
Screw thread design
The screw thread type that VIVE Tracker (3.0) uses 1/4” screw with 1.27 mm pitch. For
detailed information, please refer to ISO 1222-2010, pages 3-5.
a. Pin definition of VIVE Tracker (3.0)
To Next Page
Loading...