The remote controller transmits signals to the system.
Remote controller
17
13
SUPER BUTTON
Used to start or stop the fast cooling/heating.
(Fast cooling operates at high fan speed with
18℃ set temp automatically ; Fast heating
operates at auto fan speed with 32℃ set temp
automatically )
J1
4.2
Remote controller
Indication symbols on LCD:
Note: Each mode and relevant function will be further specified in following pages.
Signal transmit
Dry indicator
Fan only indicator
Heating indicator
Cooling indicator
High fan speed
Medium fan speed
Low fan speed
Display set temperature
Display is invalid
Display set timer
Display current time
Auto fan speed Smart indicator
Sleep indicator
I feel
Super indicator
O
10
11
13
14
3
4
ON/OFF
MODE FAN
SLEEP
SUPER
SMART
IFEEL DIMMER
TIMER ON TIMER OFF CLOCK
ON
OFF
1
2
6
7
5
8
9
12
15
14
DIMMER BUTTON
The screen brightness is decreased each time
that button is pressed and it goes blank after
pressing the button four times.
1
2
4
3
12
5
6
11
7
8
9
10
SWING BUTTON
FAN BUTTON
ROOM TEMPERATURE
SETTING BUTTONS
SLEEP BUTTON
I FEEL BUTTON
CLOCK BUTTON
ON/OFF BUTTON
SMART BUTTON
MODE BUTTON
TIMER ON/OFF BUTTON
Used to stop or start adjustment
louver swinging and set the desired up/down
airflow direction.
horizontal
15
SWING BUTTON
Used to stop or start adjustment
louver swinging and set the desired left/right
airflow direction.
vertical
Used to select fan speed in sequence
auto, high, medium or low.
Used to set or cancel Sleep Mode operation.
Used to start or stop the I feel mode. Press this
button above 5 seconds , Turn off I FEEL mode.
(In I feel mode,the Air Conditioner operates basis
temperature sensor fitted in remote instead of machine,
Advice to use I FEEL mode and the remote put
where the indoor unit receive signal easily.)
Used to set the current time.
Used to enter fuzzy logic operation directly,
regardless of the unit is on or off.
The appliance will be started when it is
energized or will be stopped when it is
in operation, if you press this button.
Press this button to select the operation mode.
Used to set or cancel the timer operation.
Used to adjust the room temperature and
the timer, also real time.
SWING
SWING
(invalid for this model)
*Note：Some remote controller models without buttons in the
dashed circle.
To Next Page
Loading...
