Need help?Do you have a question about the Huasun Wireless H3G-TA and is the answer not in the manual?
General| Frequency Resolution | 1Hz |
|---|---|
| Input Impedance | 50Ω |
| Input VSWR | <1.5 |
| RBW | 1 Hz to 1 MHz |
| VBW | 1Hz ~ 1MHz |
| Type | Handheld Spectrum Analyzer |
Lists standard configuration components and their pictures.
Details the TA Module's function, power, and interface.
Describes the CM Module's functionality, data display, and connections.
Explains the TC Module's monitoring capabilities and communication ports.
Details the Wireless Converter used for communicating with TA modules.
Instructions for numbering and labeling batteries before connecting modules.
Guidance on connecting TA test cables to battery poles.
Steps for mounting the TA module onto the battery case.
Methods for setting addresses for TA and TC modules using address modifier or software.
Procedures for mounting the Current Transfer (CT) and TC module.
Guidelines for mounting and wiring the CM module in a rack or on a battery rack.
Important notices regarding wiring clarity, orientation, and trenching.
Step-by-step guide for initial parameter settings using the Easy Setup function.
Procedure for verifying system data and parameters after setup.
How to check for alarms, their indicators, and related menus.
Details on performing manual and automatic internal resistance tests and setting base values.
Methods for checking the accuracy of voltage, temperature, and IR readings.
Connecting the CM module to a remote computer using RS485 communication.
Configuring IP settings for the CM module's LAN port.
Information on dry contact outputs for alarms and module errors.
Procedure to adjust alarm limits for battery parameters.
Configuring IR alarm limits, cycle numbers, and interval times.
Steps to connect additional strings to an existing CM module port.
Instructions for updating the CM module's firmware via Ethernet.
To Next Page