Figure 3-3 Removing the server
2. Pull out the server along the guide rails away from the cabinet. See (2) in Figure 3-3.
3. Place the removed server on an ESD platform.
Step 5 Loosen the M6 screw from the lowest square hole at the rear of a guide rail. See (1) in Figure
3-4.
Step 6 Remove the two plugs from the middle square holes on both ends. See (2) in Figure 3-4.
Step 7 Remove the guide rail from the cabinet.
1. Tilt the guide rail to unhook it from the front mounting bar. See (3) in Figure 3-4.
2. Retract the guide rail. See (4) in Figure 3-4.
3. Rilt the guide rail to unhook it from the rear mounting bar, and remove it from the
cabinet.
2288H V5 Server
User Guide
3 Basic Operations
Issue 04 (2018-09-04) Copyright © Huawei Technologies Co., Ltd. 45
To Next Page
Loading...
