10
4. Use the new password to log in to the web-based management page.
5. On the home page, click Optimize location.
6. Measure the signal strengths at the recommended installation locations following the page
instructions, and find a location with optimal signal strength.
The CPE can be installed on a pole or wall, and must be within the protection range of the lightning
rod, measured at a 45-degree angle from the top of the rod.
5 Install the CPE outdoors.
The CPE can be installed on a pole or wall. Perform the corresponding steps based on the place where
it will be installed. After the CPE is installed, use the switch under the cover to disable the Wi-Fi, then
close and secure the cover.
http://XXX.XXX.XXX.X/
Disable Mobile Data
Optimize location
45° 45°
http://XXX.XXX.XXX.X
Test Results
Excellent location
Score: 100
Optimize location
Excellent
Poor
To Next Page
Loading...
