Huawei AR Series - 3.7 Connecting the Router; 3.7.1 Connecting the Console Cable

To Next Page

To Previous Page

Step 3 Tighten the screws on the U-shaped bolts on the fixture to fix the antenna on the pole.

Step 4 Screw one end of the N-M/N-M antenna to the bottom of the antenna and the other end to the

Surge terminal of the surge protector.

NOTE

The joint between the antenna and extension cable must be sealed with waterproof insulation tape to ensure

reliable electrical connection and prevent water intrusion.

Step 5 Place the surge protector near the building where the router is located and fix the surge

protector. It is recommended that you set up a warning sign beside the surge protector.

Step 6 Use a ground cable to connect the GND terminal of the surge protector to a ground bar.

Step 7 Use a multimeter to measure the resistance between the ground cable and the ground bar.

Ensure that the resistance is smaller than or equal to 10 ohm.

Step 8 Connect the N-F end of the N-F/SMA-J extension cable to the Protect terminal of the surge

protector and the SMA-J end to the LTE interface of the router.

----End

3.7 Connecting the Router

3.7.1 Connecting the Console Cable

Context

NOTICE

l Do not power on the router before you finish connecting cables.

l Notice flags on interfaces when connecting cables. Incorrect cable connections may

damage interface modules or the router.

Tools and Accessories

l Console cable

NOTE

The console cable is not included in the installation accessory package and needs to be purchased

separately.

Procedure

Step 1 Connect the console cable.

1. Connect a DB9 connector of the console cable to the RS232 interface (DB9) of the

router.

Huawei AR500&AR530&AR550 series Industrial Switch

Routers

Hardware Installation and Maintenance Guide

3 Installing an AR500 Series Industrial Access Router

Issue 05 (2015-12-01) Huawei Proprietary and Confidential

Other manuals for Huawei AR Series