Run the display nhrp peer all command on the hub, and the command output is as follows.
[Huawei] display nhrp peer all
-------------------------------------------------------------------------------
Protocol-addr Mask NBMA-addr NextHop-addr Type Flag
-------------------------------------------------------------------------------
172.16.1.101 32 44.3.1.2 172.16.1.101 dynamic route tunnel
-------------------------------------------------------------------------------
Tunnel interface: Tunnel0/0/0
Created time : 2008.01.07-18:07:45
Expire time : 2008.01.07-20:07:52
-------------------------------------------------------------------------------
Protocol-addr Mask NBMA-addr NextHop-addr Type Flag
-------------------------------------------------------------------------------
172.16.1.102 32 44.4.1.2 172.16.1.102 dynamic route tunnel
-------------------------------------------------------------------------------
Tunnel interface: Tunnel0/0/0
Created time : 2008.01.07-18:11:51
Expire time : 2008.01.07-20:11:57
Step 6 Run the ping command on the spoke.
If you enable Spoke1 and Spoke2 to ping each other, you can see that Spoke1 and Spoke2 have
learned NHRP mapping entries from each other.
Run the display nhrp peer all command on Spoke1, and the command output is as follows.
[Huawei] display nhrp peer all
-------------------------------------------------------------------------------
Protocol-addr Mask NBMA-addr NextHop-addr Type Flag
-------------------------------------------------------------------------------
172.16.1.1 32 44.1.1.1 172.16.1.1 static hub
-------------------------------------------------------------------------------
Tunnel interface: Tunnel0/0/0
Created time : 2011.08.18-15:10:26
Expire time : --
-------------------------------------------------------------------------------
Protocol-addr Mask NBMA-addr NextHop-addr Type Flag
-------------------------------------------------------------------------------
172.16.1.102 32 44.4.1.2 172.16.1.102 dynamic route tunnel
-------------------------------------------------------------------------------
Tunnel interface: Tunnel0/0/0
Created time : 2011.08.18-16:09:31
Expire time : 2011.08.18-18:09:31
Run the display nhrp peer all command on Spoke2, and the command output is as follows.
[Huawei] display nhrp peer all
-------------------------------------------------------------------------------
Protocol-addr Mask NBMA-addr NextHop-addr Type Flag
-------------------------------------------------------------------------------
172.16.1.1 32 44.1.1.1 172.16.1.1 static hub
-------------------------------------------------------------------------------
Tunnel interface: Tunnel0/0/0
Created time : 2011.08.18-15:12:53
Expire time : --
-------------------------------------------------------------------------------
Protocol-addr Mask NBMA-addr NextHop-addr Type Flag
-------------------------------------------------------------------------------
172.16.1.101 32 44.3.1.2 172.16.1.101 dynamic route tunnel
-------------------------------------------------------------------------------
Tunnel interface: Tunnel0/0/0
Created time : 2011.08.18-16:10:33
Expire time : 2011.08.18-18:10:33
-------------------------------------------------------------------------------
Protocol-addr Mask NBMA-addr NextHop-addr Type Flag
-------------------------------------------------------------------------------
172.16.1.102 32 44.4.1.2 172.16.1.102 dynamic local
-------------------------------------------------------------------------------
Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN 6 DSVPN Configuration
Issue 01 (2012-04-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
356
To Next Page
Loading...
