Huawei AR150 series - Configuring a DHCP Server Based on an Interface Address Pool; Establishing the Configuration Task

Pool-No : 2
Lease : 3 Days 0 Hours 0 Minutes
Domain-name : -
DNS-Server0 : 10.10.10.5
DNS-Server1 : 10.10.10.6
NBNS-Server0 : 20.20.20.5
Netbios-type : -
Position : Local Status : Unlocked
Gateway-0 : 10.10.10.10
Mask : 255.255.255.0
Vpn instance : --
--------------------------------------------------------------------------
Start End Total Used Idle(Expired) Conflict
Disable
--------------------------------------------------------------------------
10.10.10.1 10.10.10.254 253 0 253 0 0
--------------------------------------------------------------------------
6.4 Configuring a DHCP Server Based on an Interface
Address Pool
This section describes how to configure a DHCP server based on an interface address pool. After
the configuration, users that get online from this interface can obtain IP addresses and other
configuration information from the address pool.
6.4.1 Establishing the Configuration Task
Before configuring a DHCP server based on an interface address pool, familiarize yourself with
the applicable environment, complete the pre-configuration tasks, and obtain the data required
for the configuration. This will help you complete the configuration task quickly and accurately.
Applicable Environment
On the AR150/200 functioning as a DHCP server, you can configure an interface address pool.
As shown in Figure 6-3, interface address pools are applicable only to the scenario where a
DHCP client and a server are on the same network segment.
Figure 6-3 Application scenario of an interface address pool
DHCP Client
DHCP Server
Pre-configuration Tasks
Before configuring a DHCP server based on an interface address pool, complete the following
tasks:
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 6 DHCP Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
137