Figure 6-6 Networking diagram for configuring a DHCP server based on an interface address
pool
DHCP
Client
DHCP
Server
NetBIOS Server
DNS Server
10.1.1.2/24
10.1.1.3/24
VLANIF10
10.1.1.1/24
VLANIF20
10.1.2.1/24
DHCP
Client
DHCP
Client
DHCP
Client
Router
Etherent0/0/0
Etherent0/0/1
Office1
Office2
Configuration Roadmap
The configuration roadmap is as follows:
1. Enable the DHCP function on the Router.
2. Configure two VLANIF interfaces, and configure IP addresses for the VLANIF interfaces
so that the interface address pool range can be determined.
3. Enable the interface address pool.
4. Configure address pool attributes for the clients, including the DNS server address,
NetBOIS server address, and IP address leases.
Data Preparation
To complete the configuration, you need the following data:
1. IP addresses of VLANIF 10 and VLANIF 20: 10.1.1.1 and 10.1.2.1 respectively
2. IP address leases for Office 1 and Office 2: 30 days and 20 days respectively
3. IP address of the DNS server: 10.1.1.2
4. IP address of the NetBIOS server: 10.1.1.3
Procedure
Step 1 Enable the DHCP service.
<Huawei> system-view
[Huawei] sysname Router
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 6 DHCP Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
161
To Next Page
Loading...
