Huawei AR150 series - Configuring TCP6; Establishing the Configuration Task; Configuring TCP6 Timers

MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
3.7 Configuring TCP6
By setting TCP6 packets, you can improve the performance of the network.
3.7.1 Establishing the Configuration Task
This section describes the applicable environment, pre-configuration tasks, data preparation, and
configuration procedure for configuring TCP6.
Applicable Environment
To optimize network performance, you need to adjust the TCP6 parameters.
Pre-configuration Tasks
Before configuring TCP6, complete the following tasks:
l Connecting and configuring the physical features for the interface and ensuring that the
status of the physical layer of the interface is Up
l Configuring the link layer protocol parameters for the interface and ensuring that the status
of the link layer protocol on the interface is Up
Data Preparation
To configure TCP6, you need the following data.
No.
Data
1 Value of TCP6 FIN-WAIT timer
2 Value of TCP6 SYN-WAIT timer
3 Size of TCP6 Sliding Window
3.7.2 Configuring TCP6 Timers
By setting two TCP6 timers, you can control the TCP connection time.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 3 Basic IPv6 Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
72