Pre-configuration Tasks
Before configuring event management, complete the following task:
l Installing system software to the router and powering it on
Data Preparation
Before configuring event management, you need the following data.
No. Data
1 Event name
2 Period after which a generated event is reported
7.4.2 Configuring Delayed Event Reporting
To control the frequency at which an event is reported, you can set a period after which a
generated event is reported.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
event
The event view is displayed.
Step 3 Run:
delay-suppression enable
The delayed event reporting function is enabled.
By default, this function is enabled to prevent events from being reported during the delay period.
Step 4 Run:
suppression event-name event-name period seconds
The period after which a generated event is reported is set.
After the delay period is set for a certain event, if an event is generated multiple times during
the delay period, the system reports only the first one to the NMS when the delay period expires
and discards the following ones.
----End
7.4.3 Checking the Configuration
After event management is configured, you can check event information.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 7 Fault Management
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
118
To Next Page
Loading...
