2.2 Installing the Device
This section describes AR150/200 installation scenarios and installation methods.
NOTE
The installation scenarios and installation methods of all AR150/200 series products are the same. This
section uses AR207G-HSPA+7 as an example.
The antenna interfaces on a AR207G-HSPA+7 can connect to whip antennas and remote antennas.
l Whip antennas are directly installed on an AR router and are recommended when a router is desk
installed or wall mounted.
l Indoor remote antennas have a 3 m long feed line. Indoor remote antennas are recommended when
an AR router is installed in a cabinet or rack, Indoor remote antennas need to be ordered separately
if needed.
Placing Chassis on the Desk
1. Before placing the AR150/200 on the desk, attach rubber pads onto each of the four recessed
corner areas on the bottom of the chassis.
2. AR207G-HSPA+7 needs two whip antennas, which must be vertical to the desktop. (Only
applies to 3G models).
Huawei AR150&200 Series Enterprise Routers
Quick Start Guide 2 Product Installation
Issue 03 (2012-06-10) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
15
To Next Page
Loading...
