NOTE
When a user runs the display this command to display system status information, other users cannot
run the same command until all the command output is displayed.
----End
3.2.3 Collecting System Diagnostic Information
This section describes how to collect information about all modules in the system.
Context
When the system fails to perform routine maintenance, you need to collect a lot of information
to locate faults. Then, you have to run different display commands to collect all information. In
this case, you can use the display diagnostic-information command to collect all information
about the current running modules in the system.
Procedure
l Run:
display diagnostic-information
The system diagnosis information is displayed.
The display diagnostic-information command collects all information collected by
running the following commands, including display clock, display version, and so on.
----End
Huawei AR2200 Series Enterprise Routers
Configuration Guide - Basic Configuration 3 Basic Configuration
Issue 02 (2011-10-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
29
To Next Page
Loading...
