Huawei AR2200 Series - Checking the Configuration

authentication-mode password
Set the authentication mode as password.
4. Run:
set authentication password { cipher | simple } password
A password for this authentication mode is set.
l Configuring Non-Authentication
1. Do as follows on the router, run:
system-view
The system view is displayed.
2. Run:
user-interface vty first-ui-number [ last-ui-number ]
The VTY user interface view is displayed.
3. Run:
authentication-mode none
The authentication mode is set to none.
----End
4.3.7 Checking the Configuration
After configuring the VTY user interface, you can view information about user interfaces, the
maximum number of VTY user interfaces, and physical attributes and configurations of user
interfaces.
Prerequisite
The configurations of the VTY user interface are complete.
Procedure
l Run the display users [ all ] command to check information about user interfaces.
l Run the display user-interface maximum-vty command to check the maximum number
of VTY user interfaces.
l Run the display user-interface [ [ ui-type ] ui-number1 | ui-number ] [ summary ]
command to check the physical attributes and configurations of user interfaces.
l Run the display local-user command to check the local user list.
l Run the display vty mode command to check the VTY mode.
----End
Example
Run the display users command, and you can view information about the current user interfaces.
<Huawei> display users
User-Intf Delay Type Network Address AuthenStatus AuthorcmdFlag
34 VTY 0 00:00:12 TEL 10.138.77.38 no
Username : Unspecified
+ 35 VTY 1 00:00:00 TEL 10.138.77.57 no
Username : Unspecified
Huawei AR2200 Series Enterprise Routers
Configuration Guide - Basic Configuration 4 Configuring User Interface
Issue 02 (2011-10-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
44