Procedure
Step 1 Run:
send { all | ui-type ui-number | ui-number1 }
You can enable message sending between user interfaces.
Step 2 Following the prompt, you can view the message to be sent. You can press Ctrl_Z or Enter to
end the display, and press Ctrl_C to abort the display.
Step 3 At the system prompt, enter Y to send the message or enter N to cancel message sending.
----End
5.5.5 Displaying Logged-in Users
After users log in, you can query information about logged-in users.
Context
User information includes the user name, address, and authentication and authorization
information.
Procedure
l Run the display users [ all ] command to view information about logged-in users.
If all is configured, information about logged-in users on all user interfaces is displayed.
----End
5.6 Configuration Examples
This section provides several examples describing how to configure user login by using a console
port, Telnet, or STelnet. You can understand the configuration procedures by referring to the
configuration flowchart. The configuration examples provide information about the networking
requirements, configuration notes, and configuration roadmap.
5.6.1 Example for Configuring User Login Through a Console Port
This part provides an configuration example describing how to configure user login through a
console port. In this configuration example, certain login settings are performed on the PC,
enabling the access to the router through a console port.
Networking Requirements
If a user modifies default values of certain parameters in the console user interface, the user
needs to reset corresponding parameters in the PC when logging in to the router through the
console port next time.
Figure 5-1 Networking diagram of user login through a console port
Huawei AR2200 Series Enterprise Routers
Configuration Guide - Basic Configuration 5 Configuring User Login
Issue 02 (2011-10-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
76
To Next Page
Loading...
