Huawei AR530 Series - Adding Member Interfaces to an Eth-Trunk

Before configuring an Eth-Trunk, ensure that both ends use the same working mode. If the local
end works in manual load balancing mode, the remote end must use the manual load balancing
mode.
----End
2.6.1.3 Adding Member Interfaces to an Eth-Trunk
Context
You can add member interfaces to an Eth-Trunk in the Eth-Trunk interface view or member
interface view.
Procedure
l Add member interfaces to an Eth-Trunk in the Eth-Trunk interface view.
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
3. Run:
trunkport interface-type { interface-number1 [ to interface-number2 ] }
&<1-8>
A member interface is added to the Eth-Trunk.
NOTE
When you add member interfaces to an Eth-Trunk in a batch, if one interface cannot be added
to the Eth-Trunk, all subsequent interfaces in the batch cannot be added to the Eth-Trunk, either.
l Add member interfaces to an Eth-Trunk in the member interface view.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The member interface view is displayed.
3. Run:
eth-trunk trunk-id
The member interface is added to an Eth-Trunk.
When adding an interface to an Eth-Trunk, pay attention to the following points:
– An Eth-Trunk contains a maximum of 8 member interfaces.
– A member interface cannot be configured with some services or static MAC addresses.
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
2 Link Aggregation Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
44