Huawei AR530 Series - Adding Member Interfaces to an Eth-Trunk

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Step 3 Run:
mode lacp-static
A working mode of the Eth-Trunk is configured.
By default, an Eth-Trunk works in manual load balancing mode.
Before configuring an Eth-Trunk, ensure that both ends use the same working mode. If the local
end works in LACP mode, the remote end must use the LACP mode.
----End
2.6.2.3 Adding Member Interfaces to an Eth-Trunk
Context
You can add member interfaces to an Eth-Trunk in the Eth-Trunk interface view or member
interface view.
Procedure
l Add member interfaces to an Eth-Trunk in the Eth-Trunk interface view.
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
3. Run:
trunkport interface-type { interface-number1 [ to interface-number2 ] }
&<1-8>
A member interface is added to the Eth-Trunk.
NOTE
When you add member interfaces to an Eth-Trunk in a batch, if one interface cannot be added
to the Eth-Trunk, all subsequent interfaces in the batch cannot be added to the Eth-Trunk, either.
l Add member interfaces to an Eth-Trunk in the member interface view.
1. Run:
system-view
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
2 Link Aggregation Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
49