Step 5 Add ports to the VLAN.
Run either of the following commands as needed:
l For access ports:
Run the port default vlan vlan-id command to add a port to a specified VLAN.
To add interfaces to a VLAN in a batch, perform either of the following configurations:
– Run the port interface-type { interface-number1 [ to interface-number2 ] } &<1-10>
command in the VLAN view to add one interface or a group of interfaces to a VLAN.
– Run the port default vlan vlan-id [ step step-number [ increased | decreased ] ]
command in the port group view.
l For trunk ports:
– Run the port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }
command to add the port to specified VLANs.
– (Optional) Run the port trunk pvid vlan vlan-id command to specify the default VLAN
for a trunk interface.
To add interfaces to a VLAN in a batch, run the port trunk allow-pass vlan vlan-id [ step
step-number [ increased | decreased ] ] command in the port group view.
l For hybrid ports:
– Run either of the following commands to add a port to VLANs in untagged or tagged
mode:
– Run the port hybrid untagged vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }
command to add a port to VLANs in untagged mode.
In untagged mode, a port removes tags from frames and then forwards the frames.
This is applicable to scenarios in which Ethernet ports are connected to terminals.
To add interfaces to a VLAN in a batch, run the port hybrid untagged vlan vlan-id
[ step step-number [ increased | decreased ] ] command in the port group view.
– Run the port hybrid tagged vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }
command to add a port to VLANs in tagged mode.
In tagged mode, a port forwards frames without removing their tags. This is applicable
to scenarios in which Ethernet ports are connected to industrial switch routeres.
To add interfaces to a VLAN in a batch, run the port hybrid tagged vlan vlan-id3
[ step step-number [ increased | decreased ] ] command in the port group view.
– (Optional) Run the port hybrid pvid vlan vlan-id command to specify the default VLAN
of a hybrid interface.
By default, all ports are added to VLAN 1.
----End
Checking the Configuration
l Run the display vlan [ { vlan-id | vlan-name vlan-name } [ verbose ] ] command to view
information about all VLANs or a specified VLAN.
3.6.2 Configuring Inter-VLAN Communication
This section describes how to configure VLANIF interfaces, sub interfaces to implement inter-
VLAN communication.
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
3 VLAN Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
95
To Next Page
Loading...
