Figure 3-23 Network diagram of VLAN aggregation
VLAN 2
VLAN 3
Router
Eth2/0/3
Eth2/0/4
Eth2/0/1
Eth2/0/2
VLAN3VLAN2
VLANIF4:10.1.1.1/24
NOTE
AR550 series do not support VLAN aggregation.
Configuration Roadmap
The configuration roadmap is as follows:
1. Add interfaces of the Router to sub-VLANs.
2. Add the sub-VLANs to the super-VLAN.
3. Configure the IP address for the super-VLAN.
4. Configure proxy ARP for the super-VLAN.
Procedure
Step 1 Set the interface type.
# Configure Ethernet 2/0/1 as an access interface.
<Huawei> system-view
[Huawei] interface ethernet 2/0/1
[Huawei-Ethernet2/0/1] port link-type access
[Huawei-Ethernet2/0/1] quit
# Configure Ethernet 2/0/2 as an access interface.
<Huawei> system-view
[Huawei] interface ethernet 2/0/2
[Huawei-Ethernet2/0/2] port link-type access
[Huawei-Ethernet2/0/2] quit
# Configure Ethernet 2/0/3 as an access interface.
<Huawei> system-view
[Huawei] interface ethernet 2/0/3
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
3 VLAN Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
111
To Next Page
Loading...
