Huawei AR550 Series - Optional) Disabling a Bridge Group from Bridging Specified Protocol Packets

Figure 9-14 Networking diagram for adding users to bridge groups
RouterA
User 3
User 4
VLAN 11
User 1 User 2
VLANIF 11
Sub interface
Perform the following steps on the user-side interface of the device.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The user-side interface view is displayed.
Step 3 Run:
bridge bridge-id
An interface is added to a bridge group.
A maximum of 20 interfaces can be added to a bridge group. Different types of interfaces can
be added to the same bridge group. Layer 2 interfaces cannot be added to a bridge group.
----End
9.6.1.3 (Optional) Disabling a Bridge Group from Bridging Specified Protocol
Packets
Context
To allow a bridge group to forward specified protocol packets, enable the function that bridges
the protocol packets on the bridge group. If a bridge group is disabled from bridging specified
protocol packets, the bridge group will discard the protocol packets.
Procedure
Step 1 Run:
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
9 Transparent Bridging Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
361