Step 2 Run:
bridge bridge-id
A bridge group is created and the bridge group view is displayed.
If the bridge group specified by bridge-id exists, the bridge group view is displayed.
Multiple devices can use the same bridge number.
----End
9.6.2.2 Adding Local Interfaces to a Bridge Group
Context
A bridge group is a virtual group. It can forward packets only after interfaces have been added
to the group.
As shown in Figure 9-15, the following methods can be used to add users to a bridge group:
l Directly add users to the bridge group. User 3 uses this method.
l Use a VLAN to add users to the bridge group. Create a VLAN on a bridge and add users
to the VLAN. Users then connect to the bridge group through the VLANIF interface. User
1 and User 2 use this method.
l Use Ethernet sub-interfaces to add users to the bridge group. This method is used when
flows on a physical interface need to be differentiated using sub-interfaces. User 4 uses this
method.
Figure 9-15 Networking diagram for adding users to bridge groups
RouterA
User 3
User 4
VLAN 11
User 1 User 2
VLANIF 11
Sub interface
Perform the following steps on the user-side interface of the device.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
9 Transparent Bridging Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
364
To Next Page
Loading...
