9.6.4.5 (Optional) Disabling a Bridge Group from Bridging Specified Protocol
Packets
Context
To allow a bridge group to forward specified protocol packets, enable the function that bridges
the protocol packets on the bridge group. If a bridge group is disabled from bridging specified
protocol packets, the bridge group will discard the protocol packets.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bridge bridge-id
The bridge group view is displayed.
Step 3 Run:
bridging { ip | others } disable
The bridge group is disabled from bridging specified protocol packets.
By default, a bridge group bridges all protocol packets.
----End
9.6.4.6 (Optional) Configuring a MAC Address Table for a Bridge Group
Context
By default, dynamic MAC address learning is enabled for a bridge group. When a network is
insecure and vulnerable to attacks, you can disable dynamic MAC address learning and use static
MAC address entries for traffic forwarding.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bridge bridge-id
The bridge group view is displayed.
Multiple devices can use the same bridge number.
Step 3 Run:
mac-address learning disable
Dynamic MAC address learning is disabled.
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
9 Transparent Bridging Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
377
To Next Page
Loading...
