Huawei AR550 Series - Monitoring the Operation of Bridge Groups

9.7.1 Monitoring the Operation of Bridge Groups
Context
During routine maintenance, you can run the following commands in any view to monitor the
operation of bridge groups.
Procedure
l Run the display bridge traffic [ bridge bridge-id | interface interface-type interface-
number ] command in any view to check whether the traffic statistics on a bridge group
have been cleared.
l Run the display bridge [ bridge-id ] information command in any view to check
information about a bridge group.
l Run the display interface bridge-if [ bridge-id ] command in any view to check
information about the Bridge-if interface of a specified bridge group, including the protocol
status, interface description, and IP address.
l Run the display mac-address [ mac-address | blackhole | static | dynamic ] [ bridge
bridge-id ] [ verbose ] command in any view to check the static, dynamic, or blackhole
MAC address entry of a specified bridge group.
l Run the display mac-address [ mac-address | interface-type interface-number ] bridge
bridge-id [ verbose ] command or display mac-address { static | dynamic } [ interface-
type interface-number ] bridge bridge-id verbose command in any view to check the static
or dynamic MAC address entry of a specified bridge group and interface.
----End
9.7.2 Clearing the Traffic Statistics of a Bridge Group
Context
Before collecting traffic statistics on a bridge group, clear the previous statistics.
NOTICE
The traffic statistics cannot be restored after being cleared.
Procedure
l Run the reset bridge bridge-id statistics command in the user view to clear the traffic
statistics of a bridge group.
----End
Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
9 Transparent Bridging Configuration
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
379