Table 3-70 LTE antenna interface attributes
Attribute Description
Connector type SMA-K (screw threads outside and a hole inside)
Standards
compliance and
frequency bands
supported
l LTE FDD: bands 1/3/8
l LTE TDD: bands 38/39/40/41
l DC-HSPA+/HSPA+/HSPA/UMTS: bands 1/5/8/9
l TD-SCDMA: bands 34/39
l GSM/GPRS/EDGE: 900/1800 (MHz)
Rate
l Frequency Division Duplexing (FDD) LTE: uplink rate of 50
Mbit/s and downlink rate of 150 Mbit/s
l Time Division Duplexing (TDD) LTE: uplink rate of 10 Mbit/s
and downlink rate of 112 Mbit/s
l High Speed Packet Access Plus (HSPA+): uplink rate of 5.76
Mbit/s and downlink rate of 21.6 Mbit/s
l Dual Carrier High Speed Packet Access Plus (DC-HSPA+):
uplink rate of 5.76 Mbit/s and downlink rate of 42 Mbit/s
l Time Division-Synchronous Code Division Multiple Access
(TD-SCDMA): uplink rate of 384 kbit/s and downlink rate of 2.8
Mbit/s
l TD-HSPA: uplink rate of 2.2 Mbit/s and downlink rate of 2.8
Mbit/s
l General Packet Radio Service (GPRS): uplink rate of 85.6 kbit/s
and downlink rate of 85.6 kbit/s
l Enhanced Data Rates for GSM Evolution (EDGE): uplink rate of
236.8 kbit/s and downlink rate of 236.8 kbit/s
l Wideband Code Division Multiple Access circuit switched
(WCDMA CS): uplink rate of 64 kbit/s and downlink rate of 64
kbit/s
l WCDMA packet switched (PS): uplink rate of 384 kbit/s and
downlink rate of 384 kbit/s
Network protocols
LTE, WCDMA, GSM
Cable type 6.3.2 LTE Whip Antenna
6.3.3 LTE Indoor Remote Antenna
6.3.4 Outdoor LTE Antenna
DI/DO interface
A DI interface receives alarm input (9.6-60 V), and a DO interface sends output signals to
instruct an external device to perform required actions. Table 3-71 lists DI/DO interface
attributes.
Huawei
AR500&AR510&AR531&AR550&1500&AR2500
Industrial Switch Routers
Hardware Description
3 Chassis
Issue 10 (2019-03-06) Copyright © Huawei Technologies Co., Ltd. 154
To Next Page
Loading...
