You can change the login password on the WebUI.
Internet Explorer 9.0 and a later version is recommended, because Internet Explorer 6.0 uses the
SSL 3.0 protocol that contains vulnerabilities.
To improve security, change the default password at your first login and regularly change the password.
It is recommended that users do not set an empty password or a simple password.
A password must meet the following rules:
A password consists of 8 to 15 characters.
A password contains at least two types of characters of the following:
− Lowercase letter
− Uppercase letter
− Digit
− Special characters, including the space character and the following: ! # $ ( )
* - . / = @ [ ] ^ _ ` { } ~ |
A password cannot be the user name or the reverse order of the user name.
A password cannot contain more than two consecutive characters that are the same
(for example, 111 is not allowed.)
By default, the function to remotely log in to the CPE WebUI over HTTPS is disabled.
The remote WebUI functions the same as the local WebUI.
The maximum number of WebUI login attempts is three. After three login failures, the
WebUI login page is locked and will be unlocked after one minutes. The lockingduration
is incremented by one minute each time the WebUI login page is locked later.
When the WebUI login password is forgotten, contact the device agent or maintenance
center to restore factory defaults; refer to the AT command manual to restore factory
defaults by yourself; or contact the device operator to reset the password through
TR-069.
The WebUI supports remote (LTE wireless link) and local (Ethernet interface or Wi-Fi
link) login. Please configure ACL rights based on scenarios to control remote and local
WebUI login. Opening unnecessary login interfaces may increase network attack risks or
lead to unauthorized login. You can use the ACL service to enable or disable remote or
local WebUI login. For details, see the section "Service Control List" in the online help
of the device WebUI.
If you do not perform any operation within 5 minutes after logging in to the WebUI, the
system automatically logs you out.
You are advised to change the password timely after first login and regularly change the
password to improve network security.
Personnel in the central office may remotely log in to the LTE CPE WebUI for CPE
management and upgrade using HTTPS.
CPEs support HTTPS and are compatible with HTTP. HTTP is not a relatively secure
protocol.
To Next Page
Loading...
